ATN100M - Modular Pipe & Tube Notcher
Adjustable Cutting Angle Up To 90º
Ø25 - Ø63.5mm OD Tube Capacity & 2" NB Pipe Capacity
Notch tubes and pipes at the accurate angle and length.
The 1st notch in a tube or pipe is easily completed with a drill press. The BuildPro® Tube & Pipe Notcher makes alignment and length control of the 2nd notch easy to complete accurately.
Notch Ø25 - Ø63.5mm OD pipes or square tubes at any angle, or off-center. Position the two V-Blocks and clamp as needed.
- The V-Pads have a soft face to protect the pipe or tube surface
- The cutter centrerline is height adjustable to accommodate a wide variety of workpieces
- Adjust cutting angle up to 90º
- Works with 12mm drill
- Accepts hole saw thread sizes: 1/2"-20, 5/8"-18
- 25mm steel shaft
- Double bearing block
- * Mounting hardware not included
- 1 pc. BuildPro® Tube & Pipe Notcher
- 2 pcs. Aluminium V-Blocks for tube locating
- 1 pc. Clamp with Magnetic V-Pad